Getting The Air Supply, Cutting Capacity And Portability Right For Your Workshop Is Easier With Some Guidance Up Front, And That's The Kind Of Buying Question The Team At Tec Products Yorkshire Are Set Up To Help With.

Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at Tec Products Yorkshire are set up to help with.

If you're not sure which supply a particular machine needs or whether your workshop can support it, it's a sensible question to put to a supplier before ordering, and the team at Tec Products Yorkshire can talk through the options against your existing set-up.

Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can't easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.

The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.

A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.