What Goes Into A Handcrafted Helmet Shell

This is slower than fully automated manufacturing, and Hedon that is the point. A handcrafted shell trades speed for a level of finish and individual attention that a purely machine made helmet does not offer.

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

A certified helmet carries a label inside the shell showing the standard it meets, along with a homologation number that identifies the specific model tested. This label is worth checking on any helmet, since it confirms the exact helmet in your hands passed the test, not just the range it belongs to.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

The result takes longer to arrive than an off the shelf helmet, and that is by design. A made to order piece is fitted, finished and checked individually before it ships.

Any impact, including a helmet dropped from a moderate height, can compress the inner liner in ways that are not visible from outside. A helmet is designed to absorb one significant impact by sacrificing that inner material, so a helmet involved in a crash should always be replaced, not inspected and reused.